Electrical work in Idaho is regulated separately from general construction. Electricians don't register with the Idaho Contractors Board. They're licensed under Chapter 10 of Title 54, "Electrical Contractors and Journeymen," administered by the Idaho Electrical Board at the Division of Occupational and Professional Licenses (DOPL). A licensed electrical contractor working within its license doesn't also need a contractor registration (Idaho Code 54-5205(1)).

Who must be licensed

Idaho Code 54-1002 makes it unlawful to act as any of these without a DOPL license:

  • an electrical contractor or limited electrical contractor (the business)
  • a residential, journeyman or master electrician (the individual)
  • a limited electrical installer or provisional journeyman electrician

Apprentices must be registered with DOPL (54-1010(3)).

Contractor vs. electrician

The definitions in 54-1003A separate the business from the person holding the tools.

License What it covers Source
Electrical contractor A business installing, or contracting to install, wires, equipment or apparatus that carry or use electric current. Must show $300,000 liability insurance and workers' comp if applicable before licensing 54-1003A(1)
Journeyman electrician Personally performs or supervises the physical installation work, or plans and lays it out 54-1003A(2)
Residential electrician Does that work in a residential setting: one- and two-family homes, townhouses, and multifamily buildings up to three stories 54-1003A(3), (12)
Master electrician Qualified to plan, lay out or design installations, and may act as a residential or journeyman electrician 54-1003A(6), 54-1002(2)
Limited electrical contractor / installer Restricted categories of work set by the board, only within that category. Limited contractors also need $300,000 liability 54-1003A(7), (8)
Apprentice Learning the trade under constant on-the-job supervision of a licensed residential, journeyman or master electrician 54-1003A(4)

Two rules in 54-1010 matter when you hire:

  • All installations made by an electrical contractor must be done by or under the direct supervision of a licensed residential, journeyman or master electrician.
  • The individual owner of an electrical contracting business must employ a full-time journeyman electrician with more than 2,000 hours of documented experience as a licensed journeyman, or a master electrician, or act as that electrician personally.

On a residential job, one licensed electrician may supervise no more than six apprentices. Outside residential settings the ratio is one to two (54-1010(3)).

No local electrician licenses

Licensing of electrical contractors and electricians is within the exclusive jurisdiction of the state. No city or county may require additional licensure, registration or fees for a licensee to work there. The state investigates and prosecutes violations, with local jurisdictions asking for investigations in their areas (54-1002(5)). A Meridian electrician's DOPL license is good in Pocatello.

Permits and inspections

Who inspects

DOPL issues electrical permits and makes inspections (54-1005(1)). The state inspection provisions don't apply inside a city or county that runs its own electrical inspection program by ordinance, using the Idaho electrical code as its standard, or that receives inspections from another city or county that does (54-1001B(1)). A city or county that drops its program must tell DOPL, and DOPL then provides electrical code enforcement there for at least one year (54-1001B(5)).

So your permit comes either from your city or county building department or from DOPL. Call your local building department first. If it doesn't do electrical inspections, DOPL's Electrical Board page has links to purchase an electrical permit and request an electrical inspection.

The power company check

Section 54-1005 builds the permit into getting power:

  • A power supplier may not connect or energize an installation covered by the chapter unless it has been inspected and passed (54-1005(3)). The board may allow certain approved installations to be connected after a licensed electrical contractor buys a permit.
  • It's unlawful for anyone other than the power supplier to energize an installation before an electrical permit covering it has been purchased (54-1005(4)).

If your project adds or changes wiring, ask the electrician who pulls the permit, and get the permit number before work starts.

Combined permits

If a plumbing or HVAC permit issued by DOPL includes part of an electrical installation, that permit and inspection satisfy the electrical permit and inspection requirements, as long as all required fees are paid (54-1016(4)).

The homeowner exemption

The chapter's licensing provisions don't apply to a property owner performing noncommercial electrical work in the owner's primary or secondary residence, associated outbuildings, or the land the buildings sit on (54-1016(2)(a)).

Three limits:

  • The exemption is from licensing only. The permit and inspection rules in 54-1005 still apply.
  • It covers the owner doing noncommercial work. A friend or handyman you pay to do the wiring isn't the owner.
  • Homeowner renewable power systems connected to the grid, such as rooftop solar, are subject to a preplan review under the local jurisdiction's policies before a permit is purchased (54-1016(2)(a)). See snow loads and building codes for the roof side of a solar project.

What other trades can wire

Some limited electrical work is allowed under other licenses (54-1016(3)):

  • HVAC licensees and plumbing certificate holders may run the circuit from a disconnect to a water heater, if the disconnect is in sight of the unit and the circuit is no more than 50 feet long.
  • HVAC licensees may install electrical connections from a disconnect to HVAC equipment under the same in-sight and 50-foot rule, electric space heaters without ductwork, ventilating fans (except ducted range hoods in homes), and control wiring of 24 volts or less for equipment of five tons or less.
  • Plumbers may not install HVAC control wiring at any voltage.

Anything beyond that, such as a new circuit for a furnace, is an electrician's job.

Fees and license terms

DOPL's Electrical Board page lists a $15 application fee and these license fees:

License License fee Renewal Term
Contractor $250 $200 2 years
Limited contractor $250 $200 2 years
Journeyman $55 $45 3 years
Master $65 $45 3 years
Apprentice $30 $30 2 years

DOPL says it began moving the Electrical Board to biennial licensure on October 30, 2026.

Penalties

Working as an electrical contractor, electrician, limited installer, trainee or apprentice without a required license or registration is a misdemeanor. The violator is also subject to civil penalties set by administrative rule, up to $3,000 per violation, and each day is a separate offense (54-1017).

Before you hire an electrician

  1. Look up the contractor license and the electrician's individual license in DOPL's license search.
  2. Ask for the certificate of liability insurance ($300,000 minimum by statute).
  3. Ask who will pull the permit and whether it comes from your city, county or DOPL.
  4. Don't let anyone energize new work before the inspection passes.
  5. On a remodel over $2,000, expect the general contractor's 45-525 disclosure.

To file a complaint against a licensee, DOPL's Electrical Board page has a File a Complaint Against a Licensee link; see the DOPL complaint process. For costs, see Idaho electrical costs, or find electricians by city, such as Boise electricians. The Idaho licensing guide compares every trade credential.

Sources

Frequently Asked Questions

Can I do my own electrical work in Idaho?

The licensing provisions of Idaho Code chapter 10 don't apply to a property owner doing noncommercial electrical work in the owner's primary or secondary residence, associated outbuildings or the land around them (54-1016(2)(a)). You still need a permit and inspection: no one other than the power supplier may energize an installation before a permit is bought, and the power supplier may not connect it until it passes inspection (54-1005(3), (4)).

What is the difference between an Idaho electrical contractor and a journeyman?

An electrical contractor is the business that installs or contracts to install electrical wiring and equipment, and must carry $300,000 liability insurance. A journeyman electrician is the individual who personally does or supervises the physical work. A residential electrician does the same work in residential settings (Idaho Code 54-1003A).

Can a city require its own electrician license?

No. Licensing of electrical contractors and electricians is within the exclusive jurisdiction of the state, and no local jurisdiction may require additional licensure, registration or fees for licensees to work there (Idaho Code 54-1002(5)). Cities and counties may still run their own permit and inspection programs.

What is the penalty for unlicensed electrical work in Idaho?

Working without a required license or registration is a misdemeanor, and the violator is also subject to civil penalties set by rule of up to $3,000 per violation. Each day is a separate offense (Idaho Code 54-1017).