A basic electrical panel upgrade costs $1,269 to $1,581 in Idaho, and a new GFCI outlet costs $289 to $360, according to Homewyse calculators run for six Idaho ZIP codes. Larger jobs, such as a standby generator, run into five figures.

Electrical costs in Idaho

Job Boise, Meridian, Nampa Idaho Falls, Twin Falls Coeur d'Alene
Electrical service panel upgrade, 100-amp, breakers not included $1,281โ€“$1,553 $1,269โ€“$1,538 $1,305โ€“$1,581
Install a GFCI outlet $292โ€“$353 $289โ€“$350 $297โ€“$360

Source: Homewyse electrical service panel upgrade and electrical outlet calculators, May 2026 cost data, run for ZIP codes 83702 Boise, 83646 Meridian, 83686 Nampa, 83401 Idaho Falls, 83301 Twin Falls and 83814 Coeur d'Alene. Accessed November 18, 2026.

Homewyse prices basic work in readily serviceable conditions. For a Boise ZIP, the panel upgrade breaks down to $111 to $136 for a 100-amp, 20-space load center, about 9.7 hours of labor at $1,144 to $1,386, and $26 to $30 in supplies; disposal is another $64 to $72. The outlet estimate is $25 to $31 for the GFCI device and about 2.1 hours of labor at $254 to $307. Adding AFCI circuit protection is an extra $113 to $137.

These are small jobs, so the price is mostly a trip and labor charge. A 200-amp service upgrade, a new meter base or a long wire run will cost far more than the basic panel swap above.

Larger projects: Cost vs Value 2025

Project Boise Mountain region National
Backup power generator $12,451 $12,481 $13,534
Solar power installation $50,972 $51,183 $55,937

Source: JLC Cost vs Value Report 2025, Boise, Idaho, accessed November 18, 2026.

Cost vs Value prices one defined project, the same in every city, using local building cost data from Verisk. In Boise, the report estimates that 79.1% of the generator's cost comes back in resale value and 23.4% for solar.

What drives electrical prices in Idaho

Labor. Idaho electricians earned a mean of $32.02 an hour in May 2025, against $34.37 nationally. Pay varies inside the state: $34.34 in Coeur d'Alene, $32.92 in Idaho Falls, $31.67 in Boise, $29.60 in Pocatello and $28.97 in Twin Falls (U.S. Bureau of Labor Statistics). Contractor rates add overhead, insurance and profit on top.

Heating and cooling loads. Switching to a heat pump or adding an EV charger, a hot tub or a shop can push an older 100-amp service past its limit. Ask the electrician for a load calculation before you assume you need a bigger service.

Older wiring. Homewyse's estimates exclude bringing existing systems up to current code. If the electrician opens a wall and finds old wiring, expect a change order.

Permits

DOPL states that a permit is required when any electrical, plumbing or HVAC work is performed. DOPL issues electrical permits, and its FAQ notes that the legislature has authorized several cities and counties to take over permitting inside their boundaries, and that a local building permit may not cover electrical work.

Boise runs its own electrical permits. Under its electrical fee schedule:

  • New service entrance, panel, subpanel or main disconnect up to 200 amps: $55; over 200 amps: $65; temporary service: $40
  • A single fixture or appliance, such as an EV outlet, electric water heater, exterior light or heat pump condenser: a $14 base fee plus $55
  • More than one fixture on an addition, alteration or repair: $110
  • Miscellaneous residential electrical work: $80
  • Residential solar panels: $110 for the electrical permit, plus a $165 solar plan review and inspection fee under Boise's building fee schedule

Low-voltage outdoor lighting doesn't need a Boise permit, according to the city's Homeowner's Guide, but any hard-wired work does.

Licensing

Electrical contractors are licensed by DOPL under Idaho Code Title 54, Chapter 10, and license holders do not also need Idaho Contractors Board registration for electrical work (Idaho Code 54-5205(1)). Ask for the license number and check it with DOPL; see our guide to the Idaho electrical contractor license. A general contractor running a remodel that includes electrical work needs its own registration, which you can check on DOPL's Search for a Registration tool.

Ways to keep the cost down

  • Group small jobs, such as outlets, a ceiling fan and a GFCI swap, into one visit.
  • Ask whether the panel quote includes breakers, the permit and any utility coordination.
  • If you plan a heat pump or EV charger in the next few years, size the panel for it now.
  • Get two written bids for the same scope and compare the labor hours.

Get electrical quotes

Request free quotes or browse electricians in Idaho, including Boise, Meridian and Idaho Falls. Planning a heat pump? See HVAC costs in Idaho. For a kitchen or bath, see remodeling costs in Idaho, and for every trade, our Idaho cost guides.

Sources

Frequently Asked Questions

Do I need a permit for electrical work in Idaho?

Yes. DOPL states that a permit is required when any electrical, plumbing or HVAC work is performed. DOPL issues electrical permits, and several cities and counties have taken over permitting within their boundaries. Boise, for example, charges $55 for a panel or service change up to 200 amps.

Can I do my own electrical work in Idaho?

On your own home, within limits. DOPL's FAQ says homeowners may buy a permit only when they themselves are doing electrical work on their own residence or related outbuildings. You can't buy a homeowner permit for someone else to do the work.

How do I check an electrician's license in Idaho?

Electrical contractors and journeymen are licensed by DOPL under Idaho Code Title 54, Chapter 10, and license holders work in their field without separate contractor registration (Idaho Code 54-5205(1)). Ask for the license number and verify it with DOPL at (208) 334-3233.

Why does a panel upgrade cost more than the panel?

Labor is most of it. In Homewyse's Boise estimate, the 100-amp panel itself is $111 to $136, while about 9.7 hours of labor runs $1,144 to $1,386. Breakers, a bigger service, a utility disconnect and permit fees are extra.